Good news, your camera is supported by SILKYPIX! You can process your RAW photos taken with the Fujifilm X-T30 camera with SILKYPIX Developer Studio Pro9 or later or SILKYPIX Developer Studio 9 or later.
Fujifilm X-T30 Features
- 26.1MP APS-C X-Trans BSI-CMOS 4 sensor
- X-Processor 4
- Hybrid AF system has 425 phase-detect points spread across the entire frame
- Burst shooting at 30 fps with no blackout (but 1.25X) crop using electronic shutter; 20 fps without crop
- 2.36M-dot OLED viewfinder w/0.62x equiv. magnification and 100 fps refresh rate in boost mode
- 3" tilting touchscreen display
- Dedicated drive, shutter speed and exposure compensation dials
- Joystick for AF point selection
- Eterna Film Simulation mode
- DCI and UHD 4K/30p capture using full width of sensor
- 4:2:0 8-bit internal recording or 4:2:2 10-bit HDMI output
- USB-C socket with headphone support
- Single SD card slot (UHS-I only)
RAW Conversion & Fujifilm X-T30
SILKYPIX Developer Studio 9 and SILKYPIX Developer Studio Pro9 added support for this camera on March 25, 2019.